An interchange helps when busy through traffic is delayed by the same crossing every trip. Begin with the movement you want to separate and the connections that would still be useful afterward. That gives you a plan before you start placing ramps.

Carry the through road above the crossing

Raise the through road before the crossing, continue over it, and connect it back at ground level on the opposite side. In an ExactChaos preview, an elevated road took one through movement over a junction that was also serving ground-level traffic. The official Trafficity store page confirms that road elevation and highway interchange design are part of the game.

Add ramps for the necessary turning movements

Connect the roads with ramps or slip lanes only where drivers need to enter, exit, or change corridors. Trace each ramp from its entry toward its destination before connecting it. Give the merge and the exit some space from the crossing where your layout allows it.

Observe the first trips through the interchange

Check that through drivers take the elevated route and that turning traffic reaches the correct road. Trafficity models drivers using slip lanes to avoid queues at junctions. Keep an eye on the receiving road. A backed-up exit can hold up the ramp even when the main crossing flows smoothly.

Frequently asked questions

Do I need a complete cloverleaf?

Start with a crossing and the ramp movements you actually need. Add connections if you find recurring trips that cannot get through.

Where should the ramps lead?

Connect each ramp to the direction its drivers need after entering or leaving the highway. Trace both trips through the network.

Why is traffic still using the street below?

Check that the elevated road connects to the intended destination on both sides. Some drivers may need the local turns that the bridge bypasses.