A ramp or diagonal connector can be awkward to place if it keeps lining up with an angle you did not choose. Disable angle snapping for that stretch and check the road's intended alignment. You can turn the setting on again when working on regular intersections.

Switch off angle snapping in the road controls

While placing a road, turn off the angle snapping setting in the road controls. Draw the new section at the angle you need and inspect both ends of it. The Trafficity Day 2 patch notes confirm that the developer made the ability to disable angle snapping easier to find.

Check whether automatic snapping is the problem

Treat auto-snapping as a separate setting when road pieces keep joining together. In an ExactChaos Desert playthrough, the player disabled auto-snapping to leave two road pieces apart and discussed angle snapping separately. For a road that points in the wrong direction, check the angle setting first. For a road that keeps joining a nearby piece, check auto-snapping.

Restore snapping when it helps with alignment

Once the angled connector is placed, restore angle snapping if you want the next roads to line up. Look at the junctions on either side of the new road and make sure the ends meet only the roads they should.

Frequently asked questions

Can I turn angle snapping back on?

Yes. Use the same setting again when aligned road placement is helpful.

Which setting should I check if two road pieces keep joining?

Check auto-snapping. The player report shows it being switched off to leave a gap between roads.

When is an unsnapped angle useful?

Try it for a diagonal link or a ramp approach that must follow a different alignment from the surrounding grid.